0000889: Record changes done to schematics and PCB between November 17, 2013 and March 5, 2014

Notes
(0002758) DeuceEFI (developer) 2014-03-06 05:16	The following changes have been made to the schematics and the PCB layout between November 17, 2013 and March 5, 2014: * Increased the injector ground holes and the injector output holes from 0.040" to 0.046". - DONE 11/17/2013 * Added through holes for USB connections to allow for a remote mounted USB connector. Also corrected all header strip drill sizes to 0.0315" for a snug fit to hold the strip during assembly. - DONE 11/17/2013 * Offset the BDM pads by 0.002" for a snug fit, corrected LSD1 pin labels and verified that I already corrected the LSD2/LSD2-IN pads to be 0.046" drill size. - DONE 11/18/2013 * Changed Port P silkscreen text on back (through hole component) side from Port P0-3 to Port P3-0 since that matches the physical order of the pins. - DONE 11/28/2013 * Eliminated Pxx designations on the wire connection points and replaced them with the PCB silkscreen designations. - DONE 12/02/2013 * Changed to separate Creative Commons and MIT licenses for PCB and Schematics, respectively, and updated TODO with fuel pump driver change to be made. - DONE 01/29/2014 * Changed fuel pump LSD out for high side driver, removed Fan and LSD1 individual low side drivers for a pair of dual MOSFET low side drivers on the schematics. - DONE 02/04/2014 * Removed direct connection between Port A7 and the Fuel Pump HSD and added connection points to solder a jumper wire to select fuel pump HSD or LSD circuit. - DONE 02/04/2014 * Changed Spare ADC and IAT cpu pin capacitor from 1uF to 0.22uF. Also changed pcb revision to 0.7-alpha. - DONE 02/05/2014 * Revised notes on the first page of the schematic. Removed the recommended connector text as it did not have enough pins for all the I/O and did not fit the enclosure without modification of the connector. - DONE 02/05/2014 * Finished placement and routing of high side driver and the low side drivers on the PCB, ran DRC and found no errors. - DONE 03/05/2014 * Change Fuel Pump relay driver from a low side driver to a high side driver for Mazda and GM stock fuel pump relay wiring. - DONE 03/05/2014 * ^ resulted in all the spare LSD outputs being changed to SOIC-8 components which brings us to a total of 4 LSD outputs plus 1 HSD output.

Relationships