FreeEMS Issues - Loader
View Issue Details
0000217LoaderFirmware Commspublic2011-07-19 15:592012-09-17 15:05
Fred 
sean94z 
normalfeatureN/A
assignedopen 
AllAllAll
 
0.1.0 
0000217: Implement Firmware Reset Button
Be able to send a reset packet to the firmware to get into the serial monitor (if the load/run switch is appropriate). Use state determined in 0000216 to enable/disable this button. And rerun the interrogation after such a reset to find out what happened.
No tags attached.

Notes
(0002143)
sean94z   
2012-09-17 14:34   
What about this:

When you click connect, if firmware is running the connect button will read "Reset Firmware". vs adding another button.
(0002145)
Fred   
2012-09-17 15:05   
You need to notify the user that it's failed, and why. Dave's pop up in MTX is on the right track IMO. In the case of this, the user has to physically change their hardware, so a pop up is not an inconvenience.

1. Connect
2A. if FW popup:"FW version XXX is running, if you're sure that you've got no unsaved tune changes, move the load jumper or load switch and click retry" with buttons "retry" and "cancel"
2B. if SM behave as before.